Struct stm32wlxx_hal::lptim::LpTim1

pub struct LpTim1 { /* private fields */ }

Low-power timer 1 driver.

Implementations

impl LpTim1

pub fn new_trigger_pin<P: LpTim1Etr>( &mut self, filter: Filter, pol: TrgPol, pin: P, cs: &CriticalSection ) -> LpTim1Trg<P>

Setup a new pin trigger.

Panics

• (debug) timer is enabled.

Example

See LpTim3::new_trigger_pin.

pub fn free_trigger_pin<P: LpTim1Etr>(&mut self, pin: LpTim1Trg<P>) -> P

Free the trigger pin previously created with new_trigger_pin.

This is will the trigger source to a software trigger.

Panics

• (debug) timer is enabled.

Example

See LpTim3::free_trigger_pin.

impl LpTim1

pub fn new_output_pin<P: LpTim1Out>( &mut self, pin: P, cs: &CriticalSection ) -> LpTim1OutPin<P>

Setup a new output pin.

pub fn free_output_pin<P: LpTim1Out>(&mut self, pin: LpTim1OutPin<P>) -> P

Free the output pin previously created with new_output_pin.

Trait Implementations

impl Debug for LpTim1

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl LpTim for LpTim1

type TrgSel = TrgSel

Trigger selection options.

fn new(tim: Self::Pac, clk: Clk, pre: Prescaler, rcc: &mut RCC) -> Self

Create a new LPTIM driver.

fn free(self) -> Self::Pac

Free the LPTIM registers from the driver.

unsafe fn pulse_reset(rcc: &mut RCC)

Reset the LPTIM peripheral.

fn enable_clock(rcc: &mut RCC)

Enable clocks for the LPTIM peripheral.

unsafe fn disable_clock(rcc: &mut RCC)

Disable the LPTIM peripheral clock.

fn clk(rcc: &RCC) -> Clk

Get the clock source.

fn hz(&self) -> &Ratio<u32>

Get the clock speed in hertz.

fn cnt() -> u16

Get the timer count.

fn isr() -> u32

Get the interrupt status.

fn set_ier(&mut self, ier: u32)

Enable and disable interrupts.

unsafe fn set_icr(&mut self, icr: u32)

Clear interrupts.

fn is_enabled(&self) -> bool

Returns true if the timer is enabled.

fn setup_trigger(&mut self, filter: Filter, pol: TrgPol, sel: Self::TrgSel)

Setup a non-pin trigger.

fn set_max_duty(&mut self, duty: u16)

Set the maximum duty cycle (autoreload value).

impl PwmPin for LpTim1

type Duty = u16

Type for the duty methods

fn disable(&mut self)

Disables a PWM channel

fn enable(&mut self)

Enables a PWM channel

fn get_duty(&self) -> Self::Duty

Returns the current duty cycle

fn get_max_duty(&self) -> Self::Duty

Returns the maximum duty cycle value

fn set_duty(&mut self, duty: Self::Duty)

Sets a new duty cycle

impl CountDown for LpTim1

type Time = u16

The unit of time used by this timer

fn start<T>(&mut self, count: T)where T: Into<Self::Time>,

Starts a new count down

fn wait(&mut self) -> Result<(), Void>

Non-blockingly “waits” until the count down finishes