Struct stm32wlxx_hal::pac::usart1::cr1::R

pub struct R(/* private fields */);

Available on crate feature stm32wl5x_cm4 only.

Register CR1 reader

Implementations

impl R

pub fn rxffie(&self) -> BitReaderRaw<RXFFIE_A>

Bit 31 - RXFIFO Full interrupt enable

pub fn txfeie(&self) -> BitReaderRaw<TXFEIE_A>

Bit 30 - TXFIFO empty interrupt enable

pub fn fifoen(&self) -> BitReaderRaw<FIFOEN_A>

Bit 29 - FIFO mode enable

pub fn m1(&self) -> BitReaderRaw<M1_A>

Bit 28 - Word length

pub fn eobie(&self) -> BitReaderRaw<EOBIE_A>

Bit 27 - End of Block interrupt enable

pub fn rtoie(&self) -> BitReaderRaw<RTOIE_A>

Bit 26 - Receiver timeout interrupt enable

pub fn over8(&self) -> BitReaderRaw<OVER8_A>

Bit 15 - Oversampling mode

pub fn cmie(&self) -> BitReaderRaw<CMIE_A>

Bit 14 - Character match interrupt enable

pub fn mme(&self) -> BitReaderRaw<MME_A>

Bit 13 - Mute mode enable

pub fn m0(&self) -> BitReaderRaw<M0_A>

Bit 12 - Word length

pub fn wake(&self) -> BitReaderRaw<WAKE_A>

Bit 11 - Receiver wakeup method

pub fn pce(&self) -> BitReaderRaw<PCE_A>

Bit 10 - Parity control enable

pub fn ps(&self) -> BitReaderRaw<PS_A>

Bit 9 - Parity selection

pub fn peie(&self) -> BitReaderRaw<PEIE_A>

Bit 8 - PE interrupt enable

pub fn txeie(&self) -> BitReaderRaw<TXEIE_A>

Bit 7 - Transmit data register empty/TXFIFO not full interrupt enable

pub fn tcie(&self) -> BitReaderRaw<TCIE_A>

Bit 6 - Transmission complete interrupt enable

pub fn rxneie(&self) -> BitReaderRaw<RXNEIE_A>

Bit 5 - Receive data register not empty/RXFIFO not empty interrupt enable

pub fn idleie(&self) -> BitReaderRaw<IDLEIE_A>

Bit 4 - IDLE interrupt enable

pub fn te(&self) -> BitReaderRaw<TE_A>

Bit 3 - Transmitter enable

pub fn re(&self) -> BitReaderRaw<RE_A>

Bit 2 - Receiver enable

pub fn uesm(&self) -> BitReaderRaw<UESM_A>

Bit 1 - USART enable in low-power mode

pub fn ue(&self) -> BitReaderRaw<UE_A>

Bit 0 - USART enable

pub fn deat(&self) -> FieldReaderRaw<u8, u8>

Bits 21:25 - Driver Enable assertion time

pub fn dedt(&self) -> FieldReaderRaw<u8, u8>

Bits 16:20 - Driver Enable deassertion time

Methods from Deref<Target = R<CR1_SPEC>>

pub fn bits(&self) -> <REG as RegisterSpec>::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CR1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<R as Deref>::Target

Dereferences the value.

impl From<R<CR1_SPEC>> for R

fn from(reader: R<CR1_SPEC>) -> R

Converts to this type from the input type.